How to install the TIMKEN cylindrical bore of bearing
TIMKEN bearing mounting due to the inner ring and the outer ring can be conveniently installed separately to the shaft and bearing seat. This should arouse the attention is what will be will have installed ring axial insertion of the outer ring of the bearing box when installed, try to make it keep concentric, to prevent bruising roller and raceway. On TIMKEN bearing inner ring and the shaft of tight fit, the outer ring bearing seat hole is a loose fit non separable bearing for installation,
The separation bearing installation due to the inner ring and the outer ring can be conveniently installed separately to the shaft and bearing seat. This should arouse the attention is what will be will have installed ring axial insertion of the outer ring of the bearing box when installed, try to make it keep concentric, to prevent bruising roller and raceway.
On the import of TIMKEN bearing inner ring and outer ring, tight fit shaft bearing seat hole is a loose fit non separable bearings were installed, the first available press bearing mounted on the shaft, and then the shaft and bearing in the bearing seat hole arranged to together, if the bearing is small, can also be used for soft metal hammer tip ferrule end of the force bearing to, but the percussion force must be uniformly distributed on the bearing ring.
The outer ring of the bearing and the bearing seat hole is tightly matched with the inner ring and the shaft, is a loose fit, can be installed on the shaft bearing.
When the TIMKEN bearing ring and a shaft or the bearing seat hole are tightly matched, using a special mounting sleeve barrel and the bearing to the shaft and bearing seat.
When the TIMKEN bearing size is larger, because the required installation force is larger, or under heavy load work bearing interference fit larger adopting cold installation difficulties, need the bearing inner ring or heat the bearing seat after installation. In the hot installation, should strictly control the heating temperature. Heating of bearing, the heating temperature shall not exceed a maximum of 1200C, should be in commonly 80 ~ 1000C. Dustproof cover or seal ring bearing can not be heated, otherwise it will cause the loss of lubricant. The heating mode can be used in inductive beauty, oil bath heating method.